DAY 1, October 20th

SESSION 1: Energy

9:00

Official Opening and Welcome Address (Prof. J.M. Albella, FUNCOAT Project Coordinator and A. Moratilla, Research and Program Division, INTA)

Energy (Part I)   Session Chairs: F.J. Pérez-Trujillo (UCM)/G. García Fuentes(AIN)

9:15

Invited lecture - 1: Sol gel anti‐reflective coatings and thin film solar collectors for CSP applications in desert environments

Dr. Christopher Sansom, Crandfield University, UK

10:00

Novel Mo‐Si₃N₄ based selective coating for high temperature concentrating solar power applications

E. Céspedes, J.A. Sánchez‐García, L. Álvarez‐Fraga, D. Hernández‐Pinilla, R. Escobar‐Galindo, O. Sánchez, J.M. Albella and C. Prieto, ICMM‐CSIC, Cantoblanco, Madrid, Spain

10:20

Cold Plasmas Used for the Fabrication of Different Components Relevant for Energy Conversion

M. Brizuela, A. Garcia‐Luis, D. Gonzalez‐Santamaria, F. Fernández‐Carretero, P. Corengia, Tecnalia, San Sebastián (Spain)

10:40

Sputtered apatite‐type lanthanum silicate thin films for SOFCs electrolytes

F. Ferreira, J.C. Oliveira, A. Cavaleiro, University of Coimbra, Portugal

11:00-11:30                               Coffee Break

Energy (Part II)   Session Chairs: M. Brizuela (Tecnalia)/G. Alcalá (UCM)

11:30

Influence of the microstructure in the high temperature corrosion resistance of CrAl(Y)N coatings deposited by PVD

S. Mato, J.C. Sánchez‐López, G. Alcalá, M. Brizuela, R. Escobar Galindo and F.J. Pérez, Universidad Complutense de Madrid, Spain

11:50

Coatings for Oxycombustion‐ Supercritical Steam Boilers Components

A. Agüero, I. Baraibar, V. González, M. Gutiérrez, R. Muelas and D. Plana, Instituto Nacional de Técnica Aeroespacial‐INTA, Spain

12:10

Flame spraying of Si bond coats over SiC substrates for environmental barrier coating architectures

A. Nistal, E. García, M. I. Osendi, P. Miranzo, Institute of Ceramics and Glass (ICV‐CSIC), 28049, Madrid, Spain

12:30

Comparative oxidation behaviour in water vapour between out‐of‐pack aluminides and slurry based aluminium‐based TBCs on Ni‐based superalloys

F. Pedraza, M. Brossard, B. Bouchaud, J. Balmain and G. Bonnet, Université de La Rochelle, France.

12:50

Surface Modification of Materials exposed to Fusion Plasma and Impact on Reactor Operation

F. L. Tabarés, A. de Castro, D. Alegre, A.B. Martin‐Rojo, E. Oyarzabal and D. Tafalla, Association EURATOM‐CIEMAT, Madrid, Spain

13:10

Surface Nitriding and Ammonia formation in N2/H2 plasmas on ITER‐relevant Plasma Facing Materials

A. de Castro, D. Alegre and F.L. Tabarés, Association EURATOM‐CIEMAT, Madrid, Spain

13:30-15:00                               Lunch Buffet

SESSION 2: Biomedical   Session Chairs: J.C. Sánchez-Lopez (ICMS-CSIC)/A.Conde (CENIM-CSIC)

15:00

Plasma Immersion Ion Implantation for MoM prosthesis application

C. Díaz, S. Mändl, R. Pereiro, Asociación de la Industria Navarra (AIN), Ingeniería de Superficies, Pamplona, Spain

15:20

An in vitro approach for “the race for the surface” theory. First results with clinical strains of Staphylococcus aureus and Staphylococcus epidermidis on Ti6Al4V

J. Esteban, M. Martínez‐Pérez, C. Pérez‐Jorge, D. Lozano, J. M. Hernandez‐Lopez, S. Portal‐Núñez, M. A. Arenas et al., ISS‐Fundación Jiménez Díaz Hospital, Madrid, Spain

15:40

Ti_1‐xAg_x and TiN‐Ag electrodes deposited on polymer based sensors for biomedical applications

S. M. Marques, N. K. Manninen, S. Lanceros‐Mendez, A. Cavaleiro, S. Carvalho, University of Minho, Guimarães, Portugal

16:00

Invited lecture - 2: The role of Ag on ZrCN coatings performance in harsh biological environments

Prof. Sandra Carvalho, Universities of Minho and Coimbra, Portugal

16:45

Tribological characterization of DLC coated CoCrMo medical grade for application in Metal‐on‐Metal joint prostheses

J. Esteve, D. Cano, G.G. Fuentes, C. Díaz, L. Martínez de Olcoz and A. Lousa, Department of Applied Physics and Optics, University of Barcelona, Barcelona (Spain)

17:05-18:00                               Poster Session and coffee break

DAY 2, October 21th

SESSION 3: Mechanical

Mechanical (Part I)   Session Chairs: J.M.Albella (ICMM-CSIC)/A.Agüero (INTA)

9:15

Invited lecture - 3: High performance cold gas spray (CGS) coatings for Xtreme wear damage resistance

Prof. Josep M. Guilemany, Thermal Spray Centre (CPT). University of Barcelona. Spain

10:00

Nano‐multilayered and nano‐composite hard PVD coatings for tool/dies at medium/high temperatures

G. G. Fuentes, E. Almandoz, Diego Otazu, Sonia Mato, F. Javier Pérez‐Trujillo, Asociación de la Industria Navarra, Spain.

10:20

On the nanostructure and oxidation protection of CrAlN and CrAlYN coatings

T. C. Rojas, S. Domínguez‐Meister, M. Brizuela, J. C. Sánchez‐López, Instituto de Ciencia de Materiales de Sevilla (CSIC‐Univ. Sevilla), Spain

10:40

High temperature oxidation behavior of MCrAlY laser cladding coatings

J. C. Pereira, J. C. Zambrano, M. J. Tobar, A. Yañez, V. Amigó, Instituto de Tecnología de Materiales, Universidad Politécnica de Valencia, España.

11:00-11:30                               Coffee Break

Mechanical (Part II)   Session Chairs: A.R.González-Elipe (ICMS-CSIC)/S.Mato (UCM)

11:30

Laser furnace surface processing of ceramics and glass

I. de Francisco, V. Rico, V. V. Lennikov, L. C. Estepa, L. A. Angurel, A. R. González‐Elipe and G. F. de la Fuente, ICMA (CSIC‐Univ. Zaragoza), Spain

11:50

Influence of peak power on the properties of Ti‐Si‐N films deposited by HiPIMS in deep oscillations magnetron sputtering (DOMS) mode

F. Fernandes, J.C. Oliveira, F. Ferreira, A. Cavaleiro, University of Coimbra, Portugal

12:10

Thermal shield coatings for C/SiC materials

12:30

Raman spectroscopy of ZrCN/ZrN multilayer coatings

F. Agulló‐Rueda and J. Barriga, Instituto de Ciencia de Materiales de Madrid, ICMM‐CSIC, Madrid, Spain

12:50

Active Screen Plasma Nitriding to improve tribology performance of Austenitic Stainless Steels with good corrosion resistance

J. A. Sánchez‐Garcia, M. Brizuela, P. Corengia, A. Larrañaga, I. Braceras, Tecnalia, San Sebastián (Spain)

13:10

Enhancement of corrosion behaviour in pressure vessels weldments through silica nanoparticles addition

E. Carneiro and S. Carvalho,University of Minho, Portugal/ Equipamento Hospitalar e Serviços Associados, Maia, Portugal

13:30-15:00                               Lunch Buffet

Monday 20th

17:05:18:00

Poster Session

P1

High temperature oxidation in steam atmosphere of nanostructured transition metal nitrides coatings on steel

A. Illana, M. A. Sánchez‐Mancilla, M. Brizuela, J.C. Sánchez‐López, F.J. Pérez and S. Mato, Universidad Complutense de Madrid, Spain

P2

Heat Treatment Diffusion Coating in SANICRO25

M. Gutiérrez, V. González and A. Agüero, National Institute of Aerospace Technology–INTA, Madrid, Spain

P3

Potential protection of YSZ thermal barrier coatings against CMAS infiltration by a sacrificial slurry based coating

V. Kuchenreuther, M. Juez‐Lorenzo, V. Kolarik, H. Fietzek, Fraunhofer‐Institute Chemical Technology ICT, Pfinztal, Germany

P4

Increase of steam oxidation resistance at 650ºC and 800ºC of AlSi‐CVD‐FBR coating on P92 steel

S.I. Castañeda and F.J. Pérez, Universidad Complutense de Madrid, Spain

P5

Anticorrosion hybrid AlPO4/Al2O3 coatings on the surface of P92 steel for oxy‐fuel power plant application

L. Davydenko, M. Nazarchuk, D. Nasiedkin, Yu. Plyuto, M. Mosquera‐Feijoo, M. Nofz, et al., Chuiko Institute of Surface Chemistry, Ukraine

P6

Exploring the aluminium slurry coatings limits for new aeronautic requirements

J. Mora and A. Agüero, National Institute of Aerospace Technology–INTA, Madrid, Spain

P7

Steam oxidation test for new generation steam power plants

T. El Baraka, I. Baráibar and A. Agüero, National Institute of Aerospace Technology–INTA, Madrid, Spain

P8

Ni aluminide coating on P92 for oxidation and corrosion protection

I. Baráibar J. A. Domínguez and A. Agüero, National Institute of Aerospace Technology–INTA, Madrid, Spain

P9

Cathodic arc evaporation and characterization of CrAlON thin films

E. Almandoz, J.F. Palacio, S. Kulkarni, R.J. Rodríguez and G. G. Fuentes, Asociación de la Industria Navarra, Spain.

P10

Ag‐containing diamond‐like carbon coatings: on their microstructure and tribo‐mechanical properties

S. Domínguez‐Meister, T. C. Rojas and J. C. Sánchez‐López, Instituto de Ciencia de Materiales de Sevilla (CSIC‐Univ. Sevilla), Spain

P11

Tribocorrosion behavior of TiBxCy/a-C nanocomposite coating in strong oxidant disinfectant solutions

E. Gracia-Escosa, I. García, J.C. Sánchez-López, M. D. Abad, A. Mariscal, M. A. Arenas, J. de Damborenea, A. Conde, CENIM-CSIC, Madrid, Spain

P12

Development of decorative coatings resistant to high temperatures

E. Carretero and R. Alonso, Department of Applied Physics, University of Zaragoza, Spain

P13

On the deposition rate of magnetron sputtered thin films at oblique angles

R. Alvarez, J.M. Garcia‐Martin, M.C. Lopez‐Santos, V. Rico, F.J. Ferrer, J. Cotrino, A.R. Gonzalez‐Elipe, A. Palmero, Instituto de Ciencia de Materiales de Sevilla, Spain

P14

Anisotropic in‐plane conductivity in plasma assisted ITO thin films prepared by e‐beam evaporation at oblique angles

J. Parra‐Barranco, A. Borras, F. Garcia, M.C. Lopez‐Santos, A.R. Gonzalez‐Elipe, A. Barranco, Instituto de Ciencia de Materiales de Sevilla, Spain